3Com 5500G-EI Command Reference Guide - Page 128
UDP Helper, Configuration, Commands, Example, debugging udp-helper, Syntax, Parameters, Description
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
128 CHAPTER 5: USING NETWORK PROTOCOL COMMANDS Example To add Ethernet1/0/1 and Ethernet1/0/2 to isolation group, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]interface gigabitethernet 1/0/1 [SW5500-GigabitEthernet1/0/1]port isolate [SW5500-GigabitEthernet1/0/1]quit [SW5500]interface gigabitethernet 1/0/2 [SW5500-GigabitEthernet1/0/2]port isolate UDP Helper Configuration Commands This section describes the commands you can use to configure and manage the UDP Helper Configuration operations on your Switch. debugging udp-helper Syntax debugging udp-helper { event | packet [ receive | send ] } undo debugging udp-helper { event | packet [ receive | send ] } View User view Parameters event UDP Helper event debugging. packet UDP Helper packet debugging. receive UDP Helper inbound packet debugging. send UDP Helper outbound packet debugging. Description Use the debugging udp-helper command to enable UDP Helper debugging. Use the undo debugging udp-helper command to disable UDP Helper debugging. By default, UDP Helper debugging is disabled. Example To enable UDP Helper packet debugging, enter the following: debugging udp-helper packet display udp-helper Syntax server display udp-helper server [ interface vlan-interface vlan_id ] View Any view