3Com 5500G-EI Command Reference Guide - Page 486
Example, snmp-agent trap enable, Syntax, Parameter, Con to send SNMP flash Trap packets.
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 486 highlights
486 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS Use the undo snmp-agent target-host command to cancel the host currently configured to receive SNMP notification. You must enter the snmp-agent trap enable command before you enter the snmp-agent target-host command. The snmp-agent trap enable command enables the device to transmit Trap packets. To send Trap messages, at least one snmp-agent target-host command should be configured. Example To enable Trap messages to be sent to 2.2.2.2 with a community name of guest, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]snmp-agent trap enable [SW5500]snmp-agent target-host trap address udp-domain 2.2.2.2 params securityname guest [SW5500] To enable Trap messages to be sent to 2.2.2.2 with a community name of public, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]snmp-agent trap enable [SW5500]snmp-agent target-host trap address udp-domain 2.2.2.2 params securityname public snmp-agent trap enable Syntax snmp-agent trap enable [ configuration | flash | ospf [ process-id ] [ ospf-trap-list ] | standard [ authentication | coldstart | linkdown | linkup | warmstart ]* | system ] undo snmp-agent trap enable [ bgp [ backwardtransition ] [ established ] | configuration | flash | ospf [ process-id ] [ ospf-trap-list ] | standard [ authentication | coldstart | linkdown | linkup | warmstart ]* | system ] View System view Parameter configuration: Configure to send SNMP configuratin Trap packets. flash: Configure to send SNMP flash Trap packets. ospf [ process-id ] [ ospf-trap-list ]: Configure to send the OSPF trap packets. process-id is the ID of the OSPF process, ranging from 1 to 65535. ospf-trap-list is the list of OSPF trap information. standard [ authentication | coldstart | linkdown | linkup | warmstart ]*: Configure to send standard Trap messages. authentication: Configure to send SNMP authentication Trap messages when authentication fails.