3Com 5500G-EI Command Reference Guide - Page 489
Example, snmp-agent usm-user, Syntax, Parameter
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 489 highlights
SNMP Configuration Commands 489 Example Configure the IP address of the VLAN interface 1 as the source address for transmitting the Trap packets. system-view System View: return to User View with Ctrl+Z. [SW5500]snmp-agent trap source vlan-interface 1 snmp-agent usm-user Syntax snmp-agent usm-user { v1 | v2c } username groupname [ acl acl-list ] undo snmp-agent usm-user { v1 | v2c } username groupname snmp-agent usm-user v3 username groupname [ authentication-mode { md5 | sha } authpassstring [ privacy-mode { des56 privpassstring }]] [ acl acl-list ] undo snmp-agent usm-user v3 username groupname { local | engineid engine-id } View System view Parameter username: Enter the user name, up to 32 characters in length. groupname: Enter the group name corresponding to that user, up to 32 characters in length. v1: Specifies the use of V1 safe mode. v2c: Specifies the use of V2c safe mode. v3: Specifies the use of V3 safe mode. authentication-mode: Specifies the use of authentication. md5: Specifies that the MD5 algorithm is used in authentication. MD5 authentication uses a128-bit password. The computation speed of MD5 is faster than that of SHA sha: Specifies that the SHA algorithm is used in authentication. SHA authentication uses a 160-bit password. The computation speed of SHA is slower than that of MD5, but SHA offers higher security. authpassstring: Enter the authentication password, up to 64 characters in length. privacy-mode: Specifies the use of authentication and encryption. des 56: Specifies that the DES encryption algorithm is used. Must be entered if you enter the privacy-mode parameter.