3Com 5500G-EI Command Reference Guide - Page 381
Example, nas-ip, Syntax, Parameter, Description, primary accounting
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 381 highlights
RADIUS Protocol Configuration Commands 381 Example To set the IP address of local RADIUS authentication server to 10.110.1.2 and the password to 3Com, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]local-server nas-ip 10.110.1.2 key 3Com nas-ip Syntax nas-ip ip-address undo nas-ip View RADIUS Scheme View Parameter ip-address: IP address in dotted decimal format. Description Use the nas-ip command to set the source IP address of the network access server (NAS, the Switch in this manual), so that all packets destined for the RADIUS server carry the same source IP address. Use the undo nas-ip command to cancel the configuration. Specifying a source address for the RADIUS packets to be transmitted can avoid the situation where the packets sent back by the RADIUS server cannot be received as the result of a physical interface failure. The address of a loopback interface is usually used as the source address. By default, the source IP address of packets is the IP address of the output port. Related commands: display radius, radius nas-ip. Example To set the source IP address that is carried in the RADIUS packets sent by the NAS (the Switch) to 10.1.1.1, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]radius scheme test1 New radius scheme [SW5500-radius-test1]nas-ip 10.1.1.1 primary accounting Syntax primary accounting ip-address [ port-number ] undo primary accounting View RADIUS Scheme View