3Com 5500G-EI Command Reference Guide - Page 56
flow-control, Syntax, Parameters, Description, Example, interface, Parameter
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
56 CHAPTER 2: USING PORT COMMANDS System View: return to User View with Ctrl+Z. [SW5500]interface Gigabitethernet 1/0/1 [SW5500-GigabitEthernet1/0/1]duplex auto flow-control Syntax flow-control undo flow-control View Ethernet Port View Parameters None Description Use the flow-control command to enable flow control on an Ethernet port. This avoids discarding data packets due to congestion. Use the undo flow-control command to disable flow control. By default, flow control is disabled. Example To enable flow control on port "Ethernet1/0/1", enter the following. system-view System View: return to User View with Ctrl+Z. [SW5500]interface Gigabitethernet 1/0/1 [SW5500-GigabitEthernet1/0/1]flow-control interface Syntax interface interface_type interface_num | interface_name View System View Parameter interface_type: Enter the interface type. This can be either , GigabitEthernet, TenGigabitEthernet, Cascade. interface_number: Enter the interface number in the format unit ID/slot number/port-number. The unit ID is a number in the range 1 to 8. The slot number is a number in the range 0 to 2 The port number is a number in the range 1 to 28 or 1 to 52 depending on the number of ports you have on your unit.