3Com 5500G-EI Command Reference Guide - Page 465

Log Commands 465 For the related commands, see info-center enable, display info-center. Example Configure to send log information to the UNIX workstation at 202.38.160.1. system-view System View: return to User View with Ctrl+Z. [SW5500]info-center loghost 202.38.160.1 info-center loghost syntax source info-center loghost source interface-name undo info-center source View System view Parameter source interface-name: Sets the source address of packets sent to the loghost as the address of the interface specified by interface-name. Normally, the interface is a VLAN interface. Description Use the info-center loghost source command to set the source address of packets sent to the loghost as the address of the interface specified by the interface-name parameter. Use the undo info-center loghost source command to cancel the setting of the source address of the packets sent to the loghost. This command takes effect only after the system logging is enabled. Related commands: info-center enable, display info-center. Example Set the source address of the packets sent to the loghost as the address of the VLAN interface 1. system-view System View: return to User View with Ctrl+Z. [SW5500]info-center loghost source vlan-interface 1 info-center monitor Syntax channel info-center monitor channel { channel-number | channel-name } undo info-center monitor channel View System view Parameter channel-number: Channel number, ranging from 0 to 9, that is, the system has ten channels.