3Com 5500G-EI Command Reference Guide - Page 487
Description, Example, snmp-agent trap life, Syntax, Parameter
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 487 highlights
SNMP Configuration Commands 487 coldstart: Configure to send SNMP cold start Trap messages when switch is rebooted. linkdown: Configure to send SNMP link down Trap messages when switch port turns down. linkup: Configure to send SNMP link up Trap messages when switch port turns up. warmstart: Configure to send SNMP warm start Trap messages when snmp is re-enabled. system: Configure to send SysMib trap messages. Description Use the snmp-agent trap enable command to enable the device to send Trap message. Use the undo snmp-agent trap enable command to disable Trap message sending. By default, Trap message sending is disabled. The snmp-agent trap enable command and the snmp-agent target-host command should be used at the same time. The snmp-agent target-host command specifies which hosts can receive Trap message. To send Trap messages, at least one snmp-agent target-host command should be configured. Example Enable to send the trap packet of SNMP authentication failure to 10.1.1.1. The community name is guest. system-view System View: return to User View with Ctrl+Z. [SW5500]snmp-agent trap enable standard authentication [SW5500]snmp-agent target-host trap address udp-domain 10.1.1.1 param securityname guest snmp-agent trap life Syntax snmp-agent trap life seconds undo snmp-agent trap life View System view Parameter seconds: Specify the timeouts, ranging from 1 to 2592000 seconds. By default, the timeout interval is 120 seconds. Description Use the snmp-agent trap life command to set the timeout of Trap packets. Use the undo snmp-agent trap life command to restore the default value. The set timeout of Trap packet is represented by seconds. If time exceeds seconds, this Trap packet will be discarded.