3Com 5500G-EI Command Reference Guide - Page 351
Example, dot1x supp-proxy-check, Syntax, Parameter, Description
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 351 highlights
802.1x Configuration Commands 351 the authentication request frame only once. 2 indicates that the Switch is configured to transmit authentication request frame once again when no response is received for the first time and so on. This command has an effect on all the ports after configuration. Related commands: display dot1x. Example To configure the current device to transmit an authentication request frame to the user for no more than 9 times, enter the following: system-view System View: return to User View with Ctrl-Z [SW5500]dot1x retry 9 dot1x supp-proxy-check Syntax dot1x supp-proxy-check { logoff | trap } [ interface interface-list ] undo dot1x supp-proxy-check { logoff | trap } [ interface interface-list ] View Ethernet Port View Parameter logoff: Cuts network connection to a user upon detecting the use of proxy. trap: Sends a trap message upon detecting a user using proxy to access the Switch. interface interface-list: Ethernet interface list including several Ethernet interfaces, expressed in the format interface-list = { interface-num [ to interface-num ] } & < 1-10 >. interface-num specifies a single Ethernet interface in the format interface-num = { interface-type interface-num | interface-name }, where interface-type specifies the interface type, interface-num specifies the interface number and interface-name specifies the interface name. For the respective meanings and value ranges, see the parameters in the Port Command chapter. Description Use the dot1x supp-proxy-check command to configure the control method for 802.1x proxy users on the specified interface. Use the undo dot1x supp-proxy-check command to cancel the control method set for 802.1x proxy users. Note that when performing this function, the user logging on via proxy needs to run the 3Com 802.1x client program, (3Com 802.1x client program version V1.29 or above is needed). This command is used to set a control method on the specified interface when executed in System View. The parameter interface-list cannot be input when the command is executed in Ethernet Port View and it takes effect only on the current interface. After globally enabling proxy user detection and control in System View,