3Com 5500G-EI Command Reference Guide - Page 146
Routing Table Display, Commands, display ip routing-table, Syntax, Parameter, Description, Example
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 146 highlights
146 CHAPTER 6: USING ROUTING PROTOCOL COMMANDS ■ if-match tag ■ ip ip-prefix ■ route-policy Route Capacity Configuration Commands ■ display memory ■ display memory limit ■ memory auto-establish disable ■ memory auto-establish enable ■ memory { safety | limit } Routing Table Display Commands This section describes the commands you can use to display routing table information. When the Switch runs a routing protocol, it is able to perform the functions of a router. The term router in this section can refer either to a physical router, or to the Switch running a routing protocol. display ip routing-table Syntax display ip routing-table View All views Parameter None Description Use the display ip routing-table command to view a summary of routing table information Each line in the table represents one route. The displayed information includes destination address/mask length, protocol, preference, cost, next hop and output interface. Only the currently used route, that is the best route, is displayed. Example To view a summary of routing table information, enter the following: display ip routing-table The information displays in the following format: Routing Table: public net Destination/Mask Proto Pre Cost 1.1.1.0/24 DIRECT 0 0 1.1.1.1/32 DIRECT 0 0 2.2.2.0/24 DIRECT 0 0 2.2.2.1/32 DIRECT 0 0 Nexthop 1.1.1.1 127.0.0.1 2.2.2.1 127.0.0.1 Interface Vlan-interface1 InLoopBack0 Vlan-interface2 InLoopBack0