3Com 5500G-EI Command Reference Guide - Page 414
Example, display startup, Syntax, Parameter, Description, reset, saved-configuration
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 414 highlights
414 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS configurations of the protocol views are displayed when executing this command in protocol sub-views. For the related command, see save, reset, saved-configuration, display current-configuration, display saved-configuration. Example Display the configuration parameters for the current view of the switch system. [SW5500]display this display startup Syntax display startup [ unit unit-id ] View All views Parameter unit unit-id: Specify the Unit ID of switch. Description Use the display startup command, to display the related system software and configuration filenames used for the current and the next start-ups. This command is used to display the following information: ■ Filename of the system software configured by the user ■ Filename of the system software actually used for this startup ■ Filename of the system software configured for the next startup ■ Configuration filename used for the current startup ■ Configuration filename configured for the next startup. For the related command, see startup saved-configuration. Example Display the filenames related to the current and the next enabling. display startup UNIT1: Startup saved-configuration file: Next startup saved-configuration file: Bootrom-access enable state: flash:/sw5500cfg.cfg flash:/sw5500cfg.cfg enabled reset Syntax saved-configuration reset saved-configuration View User view