3Com 5500G-EI Command Reference Guide - Page 301

QoS Configuration Commands List 301 Parameters inbound: specify the traffic received by the Ethernet port. ip-group acl-number: Activates IP ACLs, including basic and advanced ACLs. acl-number: Sequence number of ACL, ranging from 2000 to 3999. link-group acl-number: Activates Layer 2 ACLs. acl-number: Sequence number of ACL, ranging from 4000 to 4999. rule rule: Specifies the subitem of an active ACL, ranging from 0 to 65534; if not specified, all subitems of the ACL will be activated. If only an IP ACL or a Layer 2 ACL is activated, this parameter can be omitted. If both IP and Layer 2 ACLs are activated at the same time, the rule parameter cannot be omitted. Description Use the reset traffic-statistic command to reset the traffic statistics information. This command is used for clearing the statistics information about all the traffic or a specified one. Figure 1 Comparison of Statistics Information reset Commands Commnad Function reset acl counter Reset the statistics information of the ACL which is used in the case of filtering or classifying the data treated by the software of the Switch. The case includes: ACL cited by route policy function, ACL used for control logon user, etc. reset traffic-statist ic Reset statistic information of traffic. This command is used in the case of filtering or classifying the data transmitted by the hardware of the Switch. Commonly, this command is used to reset the statistics information of the traffic-statistic command. Example Clear the statistics information about ACL 2000. system-view System View: return to User View with Ctrl+Z [SW5500]interface gigabitethernet 1/0/1 [SW5500-GigabitEthernet1/0/1]reset traffic-statistic inbound ip-group 2000 traffic-limit traffic-limit inbound { ip-group acl-number [ rule rule [ link-group acl-number rule rule ]] | link-group acl-number [ rule rule ] } target-rate [ exceed action ] undo traffic-limit inbound { ip-group acl-number [ rule rule [ link-group acl-number rule rule ] ] | link-group acl-number [ rule rule ] } View Ethernet Port View