Home » 3Com Manuals » Hubs & Switches » 3Com 5500G-EI » Manual Viewer

3Com 5500G-EI Command Reference Guide - Page 275

pim sm, Syntax, Parameter, Description, Example, pim timer hello, Enable PIM-SM on VLAN-interface10.

UPC - 662705493534

Add to My Manuals
Save this manual to your list of manuals

Page 275 highlights

PIM Configuration Commands 275 [SW5500-acl-basic-2000]rule permit source 10.10.1.2 0 [SW5500-acl-basic-2000]rule deny source 10.10.1.1 0 pim sm Syntax pim sm undo pim sm View Interface View Parameter None Description Use the pim sm to enable the PIM-SM protocol on an interface. Use the undo pim sm to disable the PIM-SM protocol. By default, PIM-SM is disabled. Once PIM-SM is enabled on an interface, PIM-DM cannot be enabled on the same interface and vice versa. Example Enable PIM-SM on VLAN-interface10. system-view System View: return to User View with Ctrl+Z [SW5500]multicast routing-enable [SW5500]interface Vlan-interface-10 [SW5500-vlan-interface10]pim sm pim timer hello Syntax pim timer hello seconds undo pim timer hello View Interface View Parameter seconds: Interval of sending Hello messages in second ranging from 1 to 18000. By default, the interval value is 30 seconds. Description Use the pim timer hello to configure the interval of sending PIM router Hello messages. Use the undo pim timer hello to restore the default interval value.

Section	Page
About This Guide	19
Using System Access Commands	23
Using Port Commands	47
Using VLAN Commands	79
Using Power over Ethernet (PoE) Commands	91
Using Network Protocol Commands	101
Using Routing Protocol Commands	143
Using Multicast Protocol Commands	235
Using QoS/ACL Commands	281
Using RSTP Commands	317
Using Fabric Commands	337
Using AAA and RADIUS Commands	341
Using System Management Commands	397