3Com 5500G-EI Command Reference Guide - Page 177
OSPF Configuration, Commands, Description, Example, abr-summary, Syntax, Parameters
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 177 highlights
OSPF Configuration Commands 177 Description Use the traffic-share-across-interface command to enable RIP to distribute traffic equally among interfaces by employing equivalent routes. Use the undo traffic-share-across-interface command to disable traffic sharing among interfaces. By default traffic sharing across RIP interfaces is disabled. Example To enable RIP traffic sharing across interfaces, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]rip [SW5500-rip]traffic-share-across-interface OSPF Configuration Commands This section describes the commands you can use to configure the Open Shortest Path First (OSPF) routing protocol. When the Switch 5500G-EI runs a routing protocol, it is able to perform the functions of a router. The term router in this section can refer either to a physical router or to the Switch 5500G-EI running a routing protocol. abr-summary Syntax abr-summary ip_address mask [ advertise | not-advertise ] undo abr-summary ip_address mask View OSPF Area view Parameters ip_address Enter a network segment IP address. mask Enter the subnet mask. advertise Enter to advertise only the summarized route. not advertise Enter to not advertise routes matching the specified IP address and mask. Description Use the abr-summary command to configure route aggregation on the area border router. Use the undo abr-summary command to disable route aggregation on the area border router. This is the default. This command is applicable only to an area border router (ABR) and is used for the route aggregation in an area. The ABR only transmits an aggregated route to other areas. Route aggregation refers to the routing information that is processed in the