3Com 5500G-EI Command Reference Guide - Page 337
Using Fabric Commands
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 337 highlights
9 USING FABRIC COMMANDS This chapter describes how to use the following commands: Fabric Configuration Commands ■ display xrn-fabric ■ change self-unit ■ change unit-id ■ set unit name ■ sysname Fabric Commands This section describes how to use the Fabric configuration commands on your Switch 5500G-EI. display xrn-fabric Syntax display xrn-fabric View Any view Parameter None Description Use the display xrn-fabric command to view the information of the entire fabric, including unit ID, unit name, operation mode and the roll of a device (master or slave). An asterisk (*) is used to indicate which unit you have connected to via a console connection. Example To display fabric information, enter the following: [SW5500]display xrn-fabric Fabric name is SW5500 , system mode is L3. Fabric authentication: NOT SUPPORT, unit number: 1. Unit Name Unit ID SW5500 1(*) change self-unit Syntax change self-unit to { 1 | auto-numbering }