3Com 5500G-EI Command Reference Guide - Page 343

802.1x Configuration Commands 343 802.1x Configuration Commands This section describes how to use the 802.1x configuration commands on your Switch 5500G-EI. display dot1x Syntax display dot1x [ sessions | statistics [ interface interface-list ]] View All views Parameter interface: Displays the 802.1x information on the specified interface. sessions: Displays the session connection information of 802.1x. statistics: Displays the relevant statistics information of 802.1x. interface-list: Ethernet interface list including several Ethernet interfaces, expressed in the format interface-list = { interface-num [ to interface-num ] } & < 1-10 >. interface-num specifies a single Ethernet interface in the format interface-num = { interface-type interface-num | interface-name }, where interface-type specifies the interface type, interface-num specifies the interface number and interface-name specifies the interface name. For the respective meanings and value ranges, read the Parameter of the Port Command Manual section. Description Use the display dot1x command to view the relevant information of 802.1x, including configuration information, running state (session connection information) and relevant statistics information. By default, all the relevant 802.1x information about each interface will be displayed. This command can be used to display the following information on the specified interface: 802.1x configuration, state or statistics. If no port is specified when executing this command, the system will display all 802.1x related information. For example, 802.1x configuration of all ports, 802.1x session connection information, and 802.1x data statistical information. The output information of this command can help the user to verify the current 802.1x configurations so as to troubleshoot 802.1x. Related commands: reset dot1x statistics, dot1x, dot1x retry, dot1x max-user, dot1x port-control, dot1x port-method, dot1x timer. Example Display the configuration information of 802.1x. display dot1x Equipment 802.1X protocol is enabled DHCP-launch is disabled EAP-relay is enabled Proxy trap checker is disabled Proxy logoff checker is disabled