3Com 5500G-EI Command Reference Guide - Page 432

432 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS For details about the interface-type, interface-num and interface-name parameters, refer to the Port Configuration in this manual. count: the display information will only contain the number of MAC addresses in the MAC address table if the user enters this parameter when using this command. Description Use the display mac-address command to display MAC address table information. When managing the Layer-2 addresses of the switch, the administrator can perform this command to view such information as the Layer-2 address table, address status (static or dynamic), Ethernet port of the MAC address, VLAN of the address, and system address aging time. For the related commands, see mac-address, mac-address timer. Example Show the information of the entry with MAC address at 00e0-fc01-0101 [SW5500]display mac-address 00e0-fc01-0101 MAC ADDR VLAN ID STATE PORT INDEX AGING TIME(s) 00e0-fc01-0101 1 Learned GigabitEthernet1/0/1 300 display mac-address Syntax aging-time display mac-address aging-time View All views Parameter None Description Use the display mac-address aging-time command to display the aging time of the dynamic entry in the MAC address table. For the related commands, see mac-address, mac-address timer, display mac-address. Examples Display the aging time of the dynamic entry in the MAC address table. [SW5500]display mac-address aging-time mac-address aging-time: 300s The above information indicates that the aging time of the dynamic entry in the MAC address is 300s. [sw5500] display mac-address aging-time mac-address aging-time: no-aging