3Com 5500G-EI Command Reference Guide - Page 466

466 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS channel-name: Specify the channel name. The name can be channel6, channel7, channel8, channel9, console, logbuffer, loghost, monitor, snmpagent, trapbuffer. Description Use the info-center monitor channel command to set the channel to output the log information to the user terminal. Use undo info-center monitor channel command to restore the channel to output the log information to the user terminal to the default value. By default, switches do not output log information to user terminal. This command takes effect only after system logging is started. For the related commands, see info-center enable, display info-center. Example Configure channel 0 to output log information to user terminal. system-view System View: return to User View with Ctrl+Z. [SW5500]info-center monitor channel 0 info-center snmp channel Syntax info-center snmp channel { channel-number | channel-name } undo info-center snmp channel View System view Parameter channel-number: Channel number, ranging from 0 to 9, that is, the system has ten channels. By default, channel 5 is used. channel-name: Specify the channel name. The name can be channel6, channel7, channel8, channel9, console, logbuffer, loghost, monitor, snmpagent, trapbuffer. Description Use the info-center snmp channel command to specify new channel for transmitting the SNMP information. Use undo info-center snmp channel command to restore the channel for transmitting the SNMP information to default value. Related commands: display snmp. Example Configure channel 6 as the SNMP information channel. system-view System View: return to User View with Ctrl+Z.