3Com 5500G-EI Command Reference Guide - Page 186

186 CHAPTER 6: USING ROUTING PROTOCOL COMMANDS View All views Parameter process-id Enter the process ID of OSPF, ranging from 1 to 65535. The command is applied to all current OSPF processes if you do not specify a process ID. Description Use the display ospf abr-asbr command to view information about the Area Border Router (ABR) and Autonomous System Border Router (ASBR) of OSPF. Example To display information on the ABR and ASBR of OSPF, enter the following: display ospf abr-asbr OSPF Process 1 with Router ID 10.110.98.138 Routing Table to ABR and ASBR I = Intra i = Inter A = ASBR B = ABR S = SumASBR Destination Area Cost Nexthop Interface IA 2.2.2.2 0.0.0.0 10 10.153.17.89 Vlan-interface1 Table 25 Output Description of the ospf abr-asbr Command Field Destination Area Cost Nexthop Interface Description Router ID of the ABR or ASBR Area where the router is connected with ASBR The routing overhead value of the route Nexthop address to the destination The local output interface display ospf Syntax asbr-summary display ospf [ process-id ] asbr-summary [ ip_address mask ] View All Views Parameters process-id: Enter the process ID of OSPF, ranging from 1 to 65535. The command is applied to all current OSPF processes if you do not specify a process ID. ip_address Enter an IP address. mask Enter an IP subnet mask. Description Use the display ospf asbr-summary command to view the summary information of an OSPF imported route, or all OSPF imported routes.