3Com 5500G-EI Command Reference Guide - Page 296
line-rate, Syntax, Parameter, Description, Example, mirrored-to, Activates Layer 2 ACLs.
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 296 highlights
296 CHAPTER 8: USING QOS/ACL COMMANDS line-rate Syntax line-rate outbound target-rate undo line-rate outbound View Ethernet Port View Parameter target-rate: The total limited rate of packets sent by interfaces. Unit in Kbps. The number inputted must be a multiple of 64. For 1000 Mbps port, the range is from 64 to 1000000. Description Use the line-rate command, to limit the total rate of the packets delivered by interfaces. Use the undo line-rate command, to cancel the configuration of limit rate at interfaces. The granularity of line rate is 64 kbps. Example Set the rate limitation of interface GigabitEthernet1/0/1 to 128 kbps. system-view System View: return to User View with Ctrl+Z [SW5500]interface gigabitethernet 1/0/1 [SW5500-GigabitEthernet1/0/1]line-rate outbound 128 [SW5500]interface gigabitethernet 1/0/1 mirrored-to Syntax mirrored-to inbound { ip-group acl-number [ rule rule [ link-group acl-number rule rule ] ] | link-group acl-number [ rule rule ] } { cpu | monitor-interface } undo mirrored-to inbound { ip-group acl-number [ rule rule [ link-group acl-number rule rule ] ] | link-group acl-number [ rule rule ] } View Ethernet Port View Parameter inbound: Performs traffic mirror for the packets received by the interface. ip-group acl-number: Activates IP ACLs, including basic and advanced ACLs. acl-number: Sequence number of ACL, ranging from 2000 to 3999. link-group acl-number: Activates Layer 2 ACLs. acl-number: Sequence number of ACL, ranging from 4000 to 4999. rule rule: Specifies the subitem of an active ACL, ranging from 0 to 65534; if not specified, all subitems of the ACL will be activated. If only IP ACL or Layer 2 ACL are activated, this parameter can be omitted. If both IP and Layer 2 ACL are activated at the same time, the rule parameter cannot be omitted.