Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 1024

setDbg setDbg Sets the debug level of the specified module. Synopsis setdbg [module_name][level] Description Use this command to set the debug level of a specified module. Debug levels filter the display of debug messages to the serial console. By default, no debug messages are displayed. High debug level values can generate a large volume of messages, degrading the system response time. The set of supported modules and their current debug levels are displayed by the command dbgShow. Notes The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric OS Commands" and "Command Availability" for details. Operands This command has the following operands: module_name Specify the name of the module for which you want to set the debug levels. Module names are case-sensitive. If this operand is omitted an error message is displayed. level Specify the debug level for the specified module (0 to 9). A zero (0) value (default) specifies that no messages are to display. Higher values cause more messages from that module to display. If this operand is omitted an error message is displayed. Examples To set the debug level for a module named NS to value 3: switch:admin> setdbg NS 3 switch:admin> dbgshow NS Module NS, debug level = 3, verbose level = 0 SEE ALSO dbgShow 1000 Brocade Fabric OS Command Reference 53-1004112-02