Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 235

extnCfg extnCfg Sets the extension mode configuration. Synopsis extncfg --ve | --ve-mode [--slot slot/] 10VE | 20VE extncfg --app-mode fcip | hybrid extncfg --config -default | -clear [-slot slot | -all] extncfg --show extncfg --help Description Use this command to set the extension mode configuration. This command switches the Field Programmable Gate Array (FPGA) images or the VE_Port mappings. Notes The execution of this command is disruptive and requires the switch reboot. The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric OS Commands" and "Command Availability" for details. Operands This command has the following operands: --slot slot/ For bladed systems only, specifies the slot number of the port to be configured,followed by a slash (/). --ve | --ve-mode 10VE | 20VE Switches the VE_Port mode between 10 VE-ports and 20 VE-ports. The default VE_Port mode is 10VE. --app-mode fcip | hybrid Sets the system extension mode to FCIP or hybrid (FCIP with IPEXT). The default APP_Port mode is FCIP. Configuring the switch for hybrid mode is disruptive. The switch reboots and loads the hybrid image. --config -default Removes active extension configurations from the specified slot or all slots. --config -clear Removes the inactive (stale) extension configurations from the specified slot or all slots. After executing this command, you must run the slotPowerOff and slotPowerOn commands for the extension blade to clear the configurations completely. -all For bladed systems only, indicates all slots in the chassis. -show Displays the current extension mode configuration. --help Displays the command usage. Brocade Fabric OS Command Reference 211 53-1004112-02