Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 153

configDownload The following rules apply to configuration download in Virtual Fabric mode: • When downloading the chassis configuration, the number of logical switches defined in the configuration download must match the number of logical switches currently defined on the switch. • When downloading the switch configuration, the target FID must be defined in both the configuration download and the current system. • When downloading the switch configuration from a specified source FID to a target FID, the target FID must be defined on the switch and the source FID and associated configuration must be defined in the configuration download. In addition, downloading an SFID configuration resets the target FID ports without warning. Caution is advised when using this option. • When downloading all configuration parameters, the number of switches defined in the downloaded configuration file must match the number of switches currently defined on the switch. In addition, the following restrictions apply: - The switches must be disabled unless you only wish to download SNMP or MAPS parameters. - Downloading a configuration file from a system that is not Virtual Fabric-capable to a system in Virtual Fabric mode is not recommended. The configuration is applied to the default switch only, and only to the ports that are part of the default switch. If an FCS policy is enabled, the following rules and restrictions apply: • Both [Defined Security Policies] and [Active Security Policies] sections must exist and contain the FCS_POLICY. • In the [Defined Security Policies] section, at least one member of the FCS_POLICY must be the same as a member in the previous FCS_POLICY. • In the [Active Security Policies] section, the FCS_POLICY must be exactly the same as the previous FCS_POLICY. Order of members must be maintained. • If either security policies section has an RSNMP_POLICY, then that section must have a WSNMP_POLICY. • After the switch is enabled, if the switch is the primary FCS, then its security and zoning information is propagated to all other switches in the fabric. • After the switch is enabled, if the switch is a non-FCS or a backup FCS, then its security and zoning information will be overwritten by the primary FCS. Security parameters and the switch identity cannot be changed by configDownload. Parameters such as the switch name and IP address are ignored; they are lines in the configuration file that begin with "boot". Security parameters and version stamp are ignored; they are the lines in the configuration file that begin with "sec". [License] is only accepted if the boot.mac parameter matches the license ID (WWN) of the switch performing the download; otherwise, it is ignored. The configuration parameters R_A_TOV, E_D_TOV, WAN_TOV, and MAX_HOPS are interrelated. Assigning a specific value to one or more of these parameters might change the range of allowed values that can be assigned to the other parameters. As a result, you may not be able to set all the values within the range displayed for each parameter. This command validates the modified values of these four parameters and terminates the download operation, if the validation check fails. This is particularly important when downloading a zoning configuration. Because the new zoning information is added to the current configuration, there might not be any conflicts. If the current zoning configuration is to be replaced, the keyword "clear:" should be inserted into the configuration file immediately before the zoning lines (starting at the line "[Zoning]"). Brocade Fabric OS Command Reference 129 53-1004112-02