Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 787

portDecom portDecom Decommissions and disables an E_Port without frame loss. Synopsis portdecom portdecom [slot/]port portdecom --help Description Use this command to disable an E_Port without frame loss. The E_Port can either be a single redundant E_Port or an E_Port which is part of a trunk group. The port must be an operational E_Port with at least one other redundant E_Port available to reach all domains that the E_Port can reach. Or the port must be an operational E_Port which is part of a trunk group with at least one other member in the trunk. The last member of the trunk group may also be decommissioned, if there are other available redundant E_Ports. Upon successful completion of the command all traffic flows on the port will have been moved to other redundant paths and the port will be placed in a persistently disabled state. To bring the port back online use the portCfgPersistentEnable command. Notes The execution of this command requires that the lossless feature is enabled on both the local switch and the remote switch on the other end of the E_Port. This command will fail for online ports, if the port is not a fully operational E_Port or trunk port, lossless is not enabled on the local or remote switch, or no alternate redundant path is available to route the traffic. A redundant path must be an E_Port connection between the same pair of switches as the E_Port that is being decommissioned. Use the topologyShow command to verify that alternate paths are available to reach all domains. When decommissioning the member of a trunk group, all members must have an equal link cost. If a member does not have an equal cost, the cost of the trunk as a whole may change after decommissioning the port and cause routes to be changed. Refer to the linkCost command for more information. The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric OS Commands" and "Command Availability" for details. Operands This command has the following operands: slot For bladed systems only, specifies the slot number of the ports to be disabled, followed by a slash (/). port Specifies the E_Port to be decommissioned. Examples SEE ALSO To decommission a port switch:user> portdecom 2/5 The port has been decommissioned and persistently disabled. dlsSet, dlsShow, linkCost, portCfgPersistentEnable, topologyShow Brocade Fabric OS Command Reference 763 53-1004112-02