Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 647

portCfg Valid options and arguments for iproute include the following: create dest_ipaddr netmask [mask] [gateway_router] Creates an IP route. Specify the following: dest_ipaddr Specifies the destination IP address in either IPv6 or IPv4 format: dest_IPv6_addr/prefix_len Specifies the destination IPv6 address of the port, if IPv6 is used. The address must be an IPv6 global, unicast address, followed by a prefix. This is used for IPv6 addresses instead of a netmask. The prefix_len operand is required. dest_IPv4_addr netmask [mask] Specifies the destination IPv4 address of the port, if IPv4 is used. If an IPv4 address is used, the subnet mask must be specified as well. Use a.b.c.d. format. The CIDR notation for IPv4 addresses can also be used. gateway_router Specifies the IP address of an IP router that can route packets to the destination virtual port IP address. The gateway address must be on the same IP subnet as one of the port IP addresses. This operand is optional with IPv6 addresses. If not specified, the gateway_router learned from the Neighbor Discovery protocol is used. -x | --crossport Configures an IP route for a failover crossport. A crossport is defined as the nonlocal (secondary) XGE port to a VE_Port group that provides failover capabilities for the tunnel configured on the local XGE port. For VE_Ports 12-21, xge1 is the local XGE port and xge0 is the crossport. For VE_Ports 22-31, xge0 is the local XGE port and xge1 is the crossport. This operand is optional and supported only on the Brocade FX8-24 XGE ports. delete ipaddr Deletes IP routes for a specified IPv4 or IPv6 address. Valid ipaddr values include the following: ipaddr Specifies IP address in either IPv6 or IPv4 format: IPv6_addr/prefix_len Specifies the IPv6 address of the virtual port, if IPv6 is used. The address must be an IPv6 global, unicast address, followed by a prefix. The prefix_len operand is required. dest_IPv4_addr netmask Specifies the destination IPv4 address of the virtual port, if IPv4 is used. If an IPv4 address is used, the subnet mask must be specified as well. Use a.b.c.d. format or the CIDR notation for IPv4 addresses. Brocade Fabric OS Command Reference 623 53-1004112-02