Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 747
Brocade X6-4 Director, port comes online only at 2 Gbps
![]() |
View all Dell Brocade G620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 747 highlights
portCfgQoS The Fabric OS port configuration commands are not supported on FCoE ports. Operands This command has the following operands: slot For bladed systems only, specifies the slot number of the port to configure, followed by a slash (/). port[-port] Specifies the port or port range to be configured, relative to the slot for bladed systems. Use switchShow for a listing of valid ports. --disable Disables the current configuration on the specified ports. When issued with the csctl_mode operand, this command disables traffic prioritization based on CS_CTL. If QoS was enabled before you enabled csctl_mode, this command restores QoS-based traffic prioritization. --enable Enables QoS or CS_CTL mode. When issued with the csctl_mode operand, this command enables traffic prioritization based on CS_CTL. When you enable csctl_mode, the command displays a message stating that QoS zones will lose priority to CS_CTL-based traffic prioritization. --resetratelimit Turns off the ingress rate limiting feature on the specified ports. --setratelimit ratelimit Sets an ingress rate limit to reduce traffic from the specified port. This configuration is applicable only to F/FL_Ports. For E/EX_Ports, this configuration would not be effective. The ingress rate limit is enforced only when a given port can run at a speed higher than the speed specified in the configuration. For example if the rate limit is set at 4 Gbps and the port comes online only at 2 Gbps, no enforcement is needed. Specify an ingress rate in Mbps. Supported values for ratelimit are: 200, 400, 600, 800, 1000, 1500, 2000, 2500, 3000, 3500, 4000, 5000, 6000, 7000, and 8000, 9000, 10000, 11000, 12000, 13000, 14000, 15000, 16000. This operand is not supported on Brocade G620 switch, Brocade X6-4 Director, and Brocade X6-8 Director. --default Applies the default configuration to the specified port. This command attempts to re-enable QoS; success depends on availability of buffers. If CS_CTL was enabled on the port, this command disables the configuration. --help Displays the command usage. Examples To enable QoS on a range of ports: switch:admin> portcfgqos --enable 1/15-18 To disable QoS on a port: switch:admin> portcfgqos --disable 1/15 Brocade Fabric OS Command Reference 723 53-1004112-02
![](/manual_guide/products/dell-brocade-g620-brocade-801-fabric-os-command-reference-c7958e0/747.png)