Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 1149

turboRamTest turboRamTest Performs a turbo SRAM test of ASIC chips. Synopsis turboramtest [--slot slot] [-passcnt count] Description Use this command to verify the chip SRAM located in the ASIC using the turbo-RAM BIST circuitry. The BIST controller is able to perform the SRAM write and read operation at a much faster rate than the PCI operation. Notes Do not abort this test prematurely, using CTRL-C or q to quit. Doing so may cause the test to report unexpected errors. Errors may vary depending on the hardware platform. You cannot interrupt the test by pressing the return key (). The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric OS Commands" and "Command Availability" for details. This diagnostic cannot be run on an operational switch. You must disable the switch using the chassisDisable command before you can run this test. After the test completes, re-enable the switch using the chassisEnable command. Operands This command has the following optional operands: --slot slot Specifies the slot number on which the diagnostic operates. All eligible blade ports in the specified slot are tested. This operand is optional. The default value is 0 and operates on fixed port count products. -passcnt count Specifies the number of times to perform this test. This operand is optional. The default value is 1. Examples To run the SRAM test with two passes: switch:admin> turboramtest -passcnt 2 Platform bladeType 154 Running turboramtest WARNING: This test should NOT be aborted in the middle. If aborted, current blade or fixed configuration switch may become unusable. Brocade Fabric OS Command Reference 1125 53-1004112-02