Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 723

portCfgLossTov portCfgLossTov Enables or disables de-bouncing of signal loss for front end ports. Synopsis portcfglosstov [slot/]port [-disable | 0] portcfglosstov [slot/]port [-enable_fixed | 1] portcfglosstov [slot/]port [-enable_all | 2] portcfglosstov -help Description Use this command to enable or disable the de-bouncing of loss of signal for 100 ms for front end ports. Use portCfgShow to display the current setting. If executed without operands, the command prints the usage. Notes The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric OS Commands" and "Command Availability" for details. On a chassis, this command must be executed on the active CP. Operands This command has the following operands: slot For bladed systems only, specifies the slot number of the port to be configured, followed by a slash (/). port Specifies the port to be configured, relative to its slot for bladed systems. Use switchShow to list valid ports. -disable | 0 Disables the configuration. -enable_fixed | 1 Enables the configuration on fixed speed ports. -enable_all | 2 Enables the configuration on autonegotiated and fixed speed ports. -help Displays the command usage. Examples To enable the configuration on fixed speed port 1/5 and to display the configuration: switch:admin> portcfglosstov 1/5 1 switch:admin> portcfgshow 1/5 Area Number: 5 Speed Level: AUTO(HW) Fill Word(On Active): 0(Idle-Idle) Fill Word(Current): 0(Idle-Idle) AL_PA Offset 13: OFF Brocade Fabric OS Command Reference 699 53-1004112-02