Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 98

bladeCfgGeMode bladeCfgGeMode Configures the operating mode of the Brocade FX8-24 blade to allow 1 GbE, 10 GbE, or both. Synopsis bladecfggemode --set mode -slot slot bladecfggemode --show -slot slot | -all bladecfggemode --help Description Use this command to configure the GbE port mode on the Brocade FX8-24 extension blade or to display the configuration. The mode configuration controls which ports are enabled. Notes The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric OS Commands" and "Command Availability" for details. This command is supported only on the Brocade FX8-24 blade in a DCX 8510 chassis. Operands This command has the following operands: --set mode Sets the GbE port mode for a specified slot. Valid modes are one of the following: 1g Enables the GbE ports ge0-ge9 (xge0 and xge1 are disabled). 10g Enables the GbE ports xge0 and xge1 (ge0-ge9 ports are disabled). dual Enables the GbE ports ge0-ge9 and xge0 (xge1 is disabled). -slot slot Specifies the slot number for the FX8-24 blade. This operand is required when setting the GbE port mode --show Displays the GbE port mode for the specified slots. -slot slot Displays the GbE port mode for a single slot. -all Displays the GbE port mode for all configured slots. --help Displays the command usage. Examples To configure the Brocade FX8-24 blade in slot 4 in 1G mode: switch:admin> bladecfggemode --set 1g -slot 4 74 Brocade Fabric OS Command Reference 53-1004112-02