Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 645

portCfg Description Operands Use this command to configure the local IP interfaces and static routes on the Brocade 7840 switch, and Brocade FX8-24 and Brocade SX6 blades. You must configure the local IP interfaces before you can create and configure FCIP tunnels. You can also create a VLAN configuration at the IP interface on the Brocade 7840 switch, and Brocade FX8-24 and Brocade SX6 blades. • portcfg ipif - Configure the local IP interfaces. • portcfg iproute - Configure a static route on the IP interface. • portcfg vlantag - Manage the IP interface VLAN configuration for FCIP. This command is suppoted on Brocade FX8-24 blade. • portcfg ipsec-policy - Include the IPsec policy. Currently supported on the Brocade 7840 switch and Brocade SX6 blade only. • portcfg lag - Configure a link aggregation group (LAG) for a GE LAN port. Supported on the Brocade 7840 switch and Brocade SX6 blade only. • portcfg tcl - Configure the Traffic Control List (TCL). Supported on the Brocade 7840 switch and Brocade SX6 blade only. • portcfg mgmtif - Creates the inband management interfaces. • portcfg mgmtroute - Creates the routes for the inband management interfaces. • portcfg autoneg - Configure autonegotiation settings for 1 GbE ports. • portcfg sla - Configure an Service Level Agreement (SLA) session. Supported on the Brocade 7840 switch and Brocade SX6 blade only. This command has the following operands: slot For bladed systems only, specifies the slot number of the port to be configured, followed by a slash (/). ge_port Specifies the number of the GbE port to be configured. The GbE ports are numbered ge0 ge9 on the Brocade FX8-24 blade and ge0 - ge17 on Brocade 7840 switch and Brocade SX6 extension blade. The two 10GbE ports on the Brocade FX8-24 blade are numbered xge0 and xge1. The Brocade 7840 switch and the Brocade SX6 extension blade has two 40GbE ports labeled ge0 and ge1, and 16 1GbE or 10GbE ports labeled ge2-ge17. For Brocade 7840 switch and the Brocade SX6 extension blade, specify GbE port number along with the DP number, for example, portcfg ipif ge0.dp0. The valid DP numbers are dp0 and dp1. For Brocade 7840 and the Brocade SX6 extension blade, specify the switch virtual interface (SVI) LAN port in "lan.dp#" format, for example, portcfg ipif lan.dp0. Use the switchShow command for a list of valid ports. ipif Defines the IP interface for both ports of a tunnel. Brocade Fabric OS Command Reference 621 53-1004112-02