Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 49

ag Notes The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric OS Commands" and "Command Availability" for details. AG is supported only on selected Brocade hardware platforms. Refer to the Access Gateway Administrator's Guide for hardware support and AG configuration procedures. In non-AG mode, only two actions are available: --modeenable and --modeshow. The --backupmappingsave, --backupmappingdel and --backupmappingshow commands can be executed if the auto policy is disabled. Operands This command has the following operands: --help Displays the command usage. --show Displays the current configuration of the Access Gateway. This includes all N_Ports and F_Ports that are currently online, failover and failback settings as well as any online F_Ports that are currently mapped to N_Ports. Failover and failback policies are displayed as enabled (1) or disabled (0). --modeshow Displays the current Access Gateway operating mode of the switch as either enabled or disabled. --modeenable Enables Access Gateway mode on a switch. Long distance mode settings should be cleared for all ports on the NPIV edge switch to which the AG is connected. Otherwise, the NPIV switch port displays the long distance port type along with the F_Port. --modedisable Disables Access Gateway mode on a switch. After AG mode is disabled, the switch reboots automatically and comes online with default zone access set to "No Access". In order to merge the switch to a fabric, set the default zone to "All Access" and disable/enable the E_Port. --policyshow Displays the supported AG port policies and their status as either enabled or disabled. AG supports four types of policies: Brocade Fabric OS Command Reference 25 53-1004112-02