Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 231

ethIf Notes The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric OS Commands" and "Command Availability" for details. Operands This command has the following operands: --set Sets a link operating mode for a network interface. interface Specifies the name of the interface, optionally enclosed in double quotation marks. Valid interfaces include the following: eth0 | eth3 Displays the link operating mode of the specified interface. The value eth3 is valid only on the CP of a Brocade DCX or DCX-4S. bond0 Displays the active Ethernet port. This operand is valid only on the CP of a DCX or a DCX-4S. -auto-negotiate | -an Configures auto-negotiation. on | off Sets auto-negotiation on or off. -speed speed Configures the speed. You can configure 1000, 100, or 10 as the speed. Note that 1000 Mbps speed can be configured only when auto-negotiation is on. -duplex Configures whether the capability of operation is full duplex or half duplex. --reseterror interface Resets error counters on the network interface. The valid values for interface are eth0 and eth3. --show Displays the link operating mode for a network interface. interface Specifies the name of the interface, optionally enclosed in double quotation marks. Valid interfaces include the following: eth0 | eth3 Displays the link operating mode of the specified interface. The value eth3 is valid only on the CP of a Brocade DCX or DCX-4S. bond0 Displays the active Ethernet port. This operand is valid only on the CP of a DCX or a DCX-4S. --help Displays the command usage. Brocade Fabric OS Command Reference 207 53-1004112-02