Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 755

portCfgShow ge_port Specifies the number of the GbE Port to be displayed. The GbE ports are numbered ge0 ge9 on the Brocade FX8-24 blade. The 10GbE ports on the Brocade FX8-24 blade are numbered xge0 and xge1. Use the switchShow command for a list of valid ports. Use portCfgShow with a GbE port or with one of the optional arguments to display specific FCIP-related parameters. Displays supported on the Brocade 7840 switch, and Brocade FX8-24 and Brocade SX6 blades When issued on the Brocade 7840 switch, and Brocade FX8-24 and Brocade SX6 blades, tunnels and parameters not applicable to these platforms are not displayed. Use the portShow command to display FCIP tunnel and circuit parameters on the Brocade FX8-24 blade. ipif Displays the IP interface configurations. IPv6 addresses are supported. arp Displays the address resolution protocol (ARP) table. This option is supported on Brocade FX8-24 and Brocade SX6 extension blades. iproute Displays the IP route on the specified GbE port. IPv6 addresses are supported. vlantag Displays the VLAN tagging configuration. For each entry, the output displays the IP interface address, the destination IP address, the VLAN ID, and the L2 CoS priority. This display includes permanent entries only. Permanent entries are configured at the IP interface level with the portCfg vlantag command. To view VLAN tagged tunnels and circuits along with permanent entries, use the portShow vlantag command. This option is suported on Brocade FX8-24 platforms mgmtif ge_port Displays the inband management interfaces configured for a specified GbE Port. The display includes the interface status (enabled or disabled), the interface IPv4 Address, the netmask, effective MTU, and annotated port flags. This option is supported on Brocade FX8-24 and Brocade SX6 extension blades. mgmtroute ge_port Displays the management routes configured for a specified GbE Port. The display includes the destination IPv4 Address, the netmask, the gateway address, and annotated port flags. This option is supported on Brocade FX8-24 and Brocade SX6 extension blades fcipcircuit Displays FCIP circuits and related parameters. fciptunnel Displays FCIP tunnels and related parameters. The following options are supported with fcipcircuit and fciptunnel: all Displays information for all FCIP tunnels. Brocade Fabric OS Command Reference 731 53-1004112-02