Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 865

portShow --filter filter_args Filters the portShow output based on the specified filter arguments. The filter arguments can be specified in any combination or as a conditional statement using the logical AND or OR operator. A conditional statement can have up to 30 conditions. This operand is supported with ipif, iproute, tcl, and lan-stats options. The following filter arguments are supported: -ipaddr ip_address Filters the output based on the specified IP address. -port [slot/]port Filters the output based on the specified port number. -tcp-port port Filters the output based on the specified TCP port number. -dp [slot/]dp# Filters the output based on the specified dual processor ID. -retransmits value Filters the output based on the retransmits exceeding specified value. -rtt ms Filters the output based on the specified circuit round trip time in milliseconds. -connect-count value Filters the output based on the connected count exceeding specified value. -bps value[k | m] Filters the output based on bandwidth (bytes per second) exceeding the specified value. Specify k for KBps and m for MBps. -or The logical OR operator. -and The logical AND operator. -default show | hide Sets the default display action if the specified filter statement is not supported. The default action is hide. Examples To display the IP interface and static route configured for failover crossports on the Brocade FX8-24: switch:admin> portshow ipif 8/xge0 Port IP Address / Pfx MTU VLAN Flags 8/xge0 192.168.10.20 / 24 1500 n/a U R M 8/xge0 192.168.11.21 / 24 1500 n/a U R M X Flags: U=Up B=Broadcast D=Debug L=Loopback P=Point2Point R=Running N=NoArp PR=Promisc M=Multicast S=StaticArp LU=LinkUp X=Crossport switch:admin> portshow iproute 8/xge0 Port IP Address / Pfx Gateway Flags 8/xge0 192.168.0.0 / 24 * U C Brocade Fabric OS Command Reference 841 53-1004112-02