Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 150
Operands, Examples, SEE ALSO, chassis parameters. This command requires chassis permissions.
View all Dell Brocade G620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 150 highlights
configDefault Note that configDefault does not completely remove all FCIP tunnels and GbE IP address information. This may be an issue when attempting to use the same information to create new tunnels or modify the existing ones. The execution of this command is subject to Virtual Fabric restrictions may be in place. Refer to "Using Fabric OS Commands" and "Command Availability" for details. Operands This command has the following operands: -fid FID Specifies the Fabric ID of the logical switch for which to reset the configuration. This operand is valid only in Virtual Fabric mode, and the executing account must have chassis permissions. -all Restores all nonpersistent configuration parameters to factory default values (switch and chassis parameters). This command requires chassis permissions. -switch Resets the switch configuration only. This operand is not valid in VF mode. -force Executes the command without confirmation and reboots the switch. This operand is optional. Examples To restore all system configuration parameters to default values: switch:admin> configdefault -all WARNING: This is a disruptive operation that requires a switch reboot. Would you like to continue [Y/N]: y Executing configdefault...Please wait Already in Native Mode continuing with configDefault Committing configuration ... done. The switch has to be rebooted to allow the changes to take effect. Switch rebooting ....... Restarting system. The system is coming up, please wait... To restore all system configuration parameters with -force option: switch:admin> configdefault -all -force Executing configdefault...Please wait setting the default config on switch sw_6510_79 Already in Native Mode continuing with configDefault Committing configuration ... done. The switch has to be rebooted to allow the changes to take effect. Switch rebooting ....... Restarting system. The system is coming up, please wait... SEE ALSO snmpConfig, configure, configureChassis, switchDisable, switchEnable 126 Brocade Fabric OS Command Reference 53-1004112-02