Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 1083

supportShow supportShow Displays switch information for debugging purposes. Synopsis supportshow supportshow slot[/port1-port2] [lines] Description Use this command to display support information from groups of preselected Fabric OS and Linux commands and other support and debugging information. You can specify a port or a range of ports for which to display this information. These commands are organized by groups, but note that the order of the groups listed below is not the same as executed by the command. The FCIP commands are supported only on the Brocade 7800 switch and the Brocade FX8-24 blade. On unsupported platforms, the command displays a "not applicable to this platform" message next to the FCIP command group. SupportShow executes commands in the following command groups. Use supportShowCfgenable or supportShowCfgDisable to modify the settings for each group. os OS group commands, enabled by default. exception Exception group commands, enabled by default. port Port group commands, enabled by default. fabric Fabric group commands, enabled by default. services Service group commands, enabled by default. security Security group commands, enabled by default. network Network group commands, enabled by default. portlog Portlog group commands, enabled by default. system System group commands, enabled by default. extend Extend group commands, disabled by default. filter Filter group commands, disabled by default. ficon FICON group commands, disabled by default. Brocade Fabric OS Command Reference 53-1004112-02 1059