Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 697

portCfgFaultDelay portCfgFaultDelay Configures the fault delay for a single FC port. Synopsis portcfgfaultdelay [slot/]port delay portcfgfaultdelay --help Description Use this command to configure the fault delay of an FC port. In the event that the link is noisy after a host power cycle, the switch may go into a soft fault state, which means a delay of R_A_TOV. Setting the mode value to 1 reduces the fault delay value to 1.2 seconds. The configuration is stored in nonvolatile memory and is persistent across switch reboots and power cycles. Use the portCfgShow command to display the user-configured fault delay settings. Notes The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric OS Commands" and "Command Availability" for details. This command is applicable only to Fibre Channel ports. Operands This command has the following operands: slot For bladed systems only, specifies the slot number of the port to be configured, followed by a slash (/). port Specifies the number of the port to be configured, relative to its slot for bladed systems. Use switchShow for a listing of valid ports. delay Specifies the fault delay value for the port number. This operand is required. Valid values are one of the following: 0 Sets the fault delay to R_A_TOV (default). 1 Sets the fault delay to 1.2 seconds. ---help Displays the command usage. Examples To set the fault delay of a port to 1.2 seconds: switch:admin> portcfgfaultdelay 2/3 1 Brocade Fabric OS Command Reference 673 53-1004112-02