Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 1194

zoneObjectReplace zoneObjectReplace Replaces zone members. Synopsis zoneobjectreplace oldmember newmember zoneobjectreplace --help Description Use this command to replace the existing member of a zone or a Peer Zone with a new member. This command can be used to replace members of an alias, but an alias itself cannot be replaced. This command is not applicable for Traffic Isolation (TI) Zones, and Frame Redirect (RD) Zones. The property member of a Peer Zone cannot be replaced using this command. Target Driven Peer Zones are not allowed to be edited using this command. For the change to become effective, enable the configuration with the cfgEnable command. Notes The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric OS Commands" and "Command Availability" for details. When an FCS policy is enabled, this command can be issued only from the primary FCS switch. Operands The following operands are required: oldmember Specifies the the zone member that has to be replaced. You can specify WWN or Domain,Index (D,I). newmember Specifies the new zone member with which to replace the old zone member. You can specify WWN or D,I. --help Displays the command usage. Examples To replace zone member: switch:admin> zoneobjectreplace \ "20:00:00:05:1e:a1:af:b2" "10:00:00:05:1e:a1:10:c1" switch:admin> cfgshow Defined configuration: cfg: cfg lsan_m cfg: cfg1 zone2; zone3 zone: lsan_m 20:15:00:05:1e:a2:f9:b1; 20:13:00:05:1e:a2:f9:b1 zone: zone1 2,3; 20:00:00:05:1e:a1:af:b1; zali_1 zone: zone2 5,7; 2,9 zone: zone3 10:00:00:05:1e:a1:10:c1; 20:10:00:05:1e:a9:20:12 1170 Brocade Fabric OS Command Reference 53-1004112-02