Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 556

mapsRule le g ge eq value action raslog decom fence snmp email sw_critical sw_marginal sfp_marginal Less than or equal to Greater than Greater than or equal to Equal to Specifies the threshold value. Valid values include the following: • For numerical values: 1-9999. • For percentage values: 1-100. • For FRU states: ON, OFF, IN, OUT, or FAULTY. • For temperature monitoring: IN_RANGE or OUT_OF_RANGE. • For FPI states: IO_FRAME_LOSS, IO_PERF_IMPACT, IO_LATENCY_CLEAR. • For Ethernet port state: UP or DOWN Specifies a comma-separated list of actions to be taken if the specified condition is evaluated to be true. The action is not taken unless it is also specified globally, using the mapsconfig --actions command. Valid actions include the following: Generates a RASLog message. Decommissions the port. Use this action along with fence. Fences the port, if port fencing is enabled. Port fencing takes the ports offline if the user-defined thresholds are exceeded. This action is valid only on conditions that are evaluated on ports. Generates an SNMP trap. Sends information about a switch event to a specified e-mail address. Sets the state of the affected switch to critical. This action is valid only if the monitor operand is one of the switch policy status monitoring systems. Sets the state of the affected switch to marginal. This action is valid only if the monitor operand is one of the switch policy status monitoring systems. Sets the state of the affected SFP transceiver to marginal. This action is valid only if the monitor operand is one of the switch policy status monitoring systems. 532 Brocade Fabric OS Command Reference 53-1004112-02