Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 643

portCfg Notes IPv6 addresses are supported except for inband management. IP Security enabled FCIP Tunnels cannot use IPv6 circuits on FX8-24 blade. The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric OS Commands" and "Command Availability" for details. Some of the features supported by this command may require a license. The Fabric OS port configuration commands are not supported on FCoE ports. Function Commands supported on all platforms Synopsis portcfg action [slot/]port arguments Description Operands Use this command to configure the following parameters on a local FC port. • portcfg mirrorport - Configure a mirror port on the local port. • portcfg rscnsupr - Manage registered state change notification (RSCN) suppression on the local port. This command has the following operands: slot For bladed systems only, specifies the slot number of the port to be configured, followed by a slash (/). port[-port] rscnsupr --disable --enable Specifies a single port or a range of ports, for example, 3-22 or 1/3-8. port ranges are supported only with the rscnsupr option. Manages Registered State Change Notification (RSCN) suppression on the local port. RSCN suppression is configurable only on FC ports. The syntax for portCfg rscnsupr is as follows: portcfg rscnsupr [slot/]port[-port] mode The following modes are supported with the rscnsupr option: Disables the configuration. When disabled, device changes on the port generate an RSCN to all other end devices that are zoned with this one. By default, RSCN suppression is disabled on all ports. Enables the configuration. When enabled, any device changes on the port will not generate an RSCN to any other end device. Brocade Fabric OS Command Reference 619 53-1004112-02