Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 646

portCfg 622 The IP network connection is configured by defining IP interfaces for origin and destination virtual ports, and then defining one or more IP routes to connect them. The syntax for portCfg ipif is as follows: portcfg ipif [slot/]ge_port option args [optional_args] Valid options and arguments for ipif include the following: create src_ipaddr netmask mtu [mask] mtu_size vlan [vlan_id] Creates IP interfaces. Specify the following: src_ipaddr Specifies source IP address in either IPv6 or IPv4 format: src_IPv6_addr/prefix_len Specifies the source IPv6 address of the port if IPv6 is used. The address must be an IPv6 global, unicast address, followed by a prefix. This is used for IPv6 addresses instead of a netmask. The prefix_len operator is required. Refer to the Fabric OS Extension Administrator's Guide for more information on IPv6 rules and restrictions. src_IPv4_addr netmask [mask] Specifies the source IPv4 address of the port, if IPv4 is used. If an IPv4 address is used, the subnet mask must be specified as well (in a.b.c.d. format). The CIDR notation for IPv4 addresses can also be used. mtu [mtu_size] Specifies the maximum transmission unit size. The permitted range is 1260 Bytes to 1500 Bytes for Brocade 7800 switch and FX8-24 blade, and 1280 Bytes to 9216 Bytes or 'auto' to enable PMTU discovery for Brocade 7840 switch and the Brocade SX6 extension blade. This operand is optional. vlan [vlan_id] Specifies the VLAN ID. This operand is optional and currently supported on the Brocade 7840 and the Brocade SX6 extension blade only. -x | --crossport Configures an interface for a failover crossport. A crossport is defined as the nonlocal (secondary) XGE port to a VE_Port group that provides failover capabilities for the tunnel configured on the local XGE port. For VE_Ports 12-21, xge1 is the local XGE port and xge0 is the crossport. For VE_Ports 22-31, xge0 is the local XGE port and xge1 is the crossport. This operand is optional and supported only on the Brocade FX8-24 XGE ports. delete ipaddr Deletes IP interfaces. Specify the IPv6 or IPv4 address of the virtual port. iproute Defines static IP routes on a GbE port or on a 10GbE port. After defining the IP interface on the remote switch, you can define destination routes for an interface. You cannot use this command to configure routes for inband management; use portCfg mgmtroute instead. The syntax for portcfg iproute is as follows: portcfg iproute [slot/]ge_port option args [optional_args] Brocade Fabric OS Command Reference 53-1004112-02