Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 695

portCfgEXPort -d domainid Specifies the preferred domain ID. For Brocade native mode (-m 0), valid values are 1 to 239. -p pidformat Specifies the Port ID format. Valid values are 0-native, 1-core, 2-extended edge. This operand is applicable only when port mode is set to 0 (native mode). If port mode is not "Brocade Native", the Port ID format displays as "Not applicable". -t fabric_parameter Enables or disables negotiation of the fabric parameters. Valid values are 1 for enable and 2 for disable. -m port mode Specifies the port mode. The -m option enforces the same port mode for all the ports connected to the same edge fabric. If this option is selected, the port mode is compared against the online ports. If the modes are different, an error message is posted, and the command fails. Valid values are as follows: 0 Brocade Native mode. 5 Brocade Network OS fabric mode. -i mode Enables or disables Insistent Domain Id (IDID) for the specified EX_Port. Specify 1 to enable IDID, specify 2 to disable IDID. This command must be issued from a McDATA edge switch attached to a single or dual FCR configuration. -- help Displays the command usage. Examples To set the fabric ID of port 2/1 to 5 and the port ID format to core: switch:admin> portcfgexport 2/1 -f 5 -p 1 To configure port 2/0 to be an EX_Port and set the fabric ID to 4: switch:admin> portcfgexport 2/0 -a 1 -f 4 To disable fabric parameter negotiation on port 2/0 of an EX_Port: switch:admin> portcfgexport 2/0 -t 2 To enable IDID on port 2: switch:admin> portcfgexport 2 -i 1 To enable Brocade Network OS (NOS) fabric mode on port 1/5: switch:admin> portcfgexport 1/5 -a 1 -m 5 To enable Brocade Network OS (NOS) fabric mode using alias name: switch:admin> portcfgexport 1/5 -a 1 -f Red_fabric Brocade Fabric OS Command Reference 671 53-1004112-02