Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 775
bad CRC payloads rx, out of seq PDUs rx, flow control count, last rtt, traceroute
![]() |
View all Dell Brocade G620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 775 highlights
portCmd bad CRC payloads rx Number of bad CRC payloads received. out of seq PDUs rx Number of out-of-sequence PDUs received. flow control count Flow control count. last rtt Last Round trip in milliseconds (RT traffic only). VLAN tagging ensures that test traffic traverses the same path as real FCIP traffic. A VLAN tag entry must exist prior to issuing the --ping or --traceroute commands; this includes both the local and remote sides. Notes End-to-end path characterization is not supported if an IPSec-enabled tunnel exists that uses the same source/local IP address. The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric OS Commands" and "Command Availability" for details. Operands This command has the following operands: slot For bladed systems only, specifies the slot number of the port to be configured, followed by a slash (/). ge port Specifies the port number of the GbE port on the blade. For the Brocade 7840 switch and the Brocade SX6 extension blade, specify GbE port number along with the DP number, for example, portcfg ipif ge0.dp0. The valid DP numbers are dp0 and dp1. --ping Pings a destination IP address from one of the source IP interfaces on the GbE port. Valid arguments and their values include the following: -s src_ip Specifies the source IP address that originates the ping request. IPv6 addresses are supported. -d dst_ip Specifies the destination IP address to which to target the ping request. IPv6 addresses are supported. -x | -crossport Specifies the source IP address as a crossport. A crossport is the nonlocal (secondary) XGE port to a VE_Port group that provides failover capabilities for the tunnel configured on the local XGE port. This operand is optional and supported only on the Brocade FX8-24 XGE ports. -n num_requests Specifies the number of ping requests. Valid values are 1 to 255. The default is 4. This operand is optional. Brocade Fabric OS Command Reference 751 53-1004112-02
![](/manual_guide/products/dell-brocade-g620-brocade-801-fabric-os-command-reference-c7958e0/775.png)