Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 1084

supportShow iswitch asic_db fcip ag dce_hsl crypto FC Router group commands, disabled by default. ASIC DB group commands, disabled by default. FCIP group commands, disabled by default. Access Gateway group commands, disabled by default. DCE group commands, enabled by default. Encryption group commands, disabled by default. Notes The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric OS Commands" and "Command Availability" for details. This is a diagnostic command and should only be run for diagnostic support. Output generated by this command may vary by switch configuration and platform. Output may change without notice. Operands This command has the following operands: slot On bladed systems only, specifies a slot number. port1-port2 lines Specifies a port or a range of ports for which to display supportShow information. This operand is optional; if omitted, the command displays information for all ports. The following values are supported: • A single port in port1-port1 format, for example, "5/8-8". • A port range where the beginning and end port are separated by a dash, for example, "5/8-13". Specifies the number of lines for the portLogDump output. This parameter is valid only with the slot/port parameters. Examples To display debugging information for a single port on a Brocade 5300: switch:admin> supportshow 43 VF Date: Sun Dec 6 05:10:13 PST 2009 Time Zone: America/Los_Angeles Version: Kernel: 2.6.14.2 1060 Brocade Fabric OS Command Reference 53-1004112-02