Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 651

portCfg -v | --vlan value Set the VLAN input filter for the specified TCL. The range is from 0 to 4095. --l2cos value Sets the Layer 2 CoS input filter for the specified TCL. --l4proto num | name Sets the Layer 4 protocol input filter for the specified TCL. Valid values for name are TCP, UDP, ICMP, VRRP and the valid range for num is from 0 through 255, or 'none' to clear the Layer 4 protocol input filter. --rst-propagation enable | disable Enables or disables end-to-end RST propagation for the specified TCL. --segment-preservation enable | disable Enables or disables segment preservation for the specified TCL. --non-terminated enable | disable Enables or disables non-terminate traffic handling for the specified TCL. mgmtif Configures an inband management interface. A maximum of one interface is supported per GbE Port. Up to a total of 11 interfaces for the Brocade FX8-24 (depending on blade operating mode). The interfaces must each exist on a unique network, separate from the other inband management interfaces and from all other interfaces on the CP. The syntax for mgmtif is as follows: mgmtif ge_port [options] arguments Valid options and arguments for mgmtif include the following: create Creates a specified IP Address for the inband management interface. The IP address must be unique. IPv4_address Specifies an IP address for the inband management interface in IPv4 format, followed by the subnet mask. netmask Specifies the subnet mask for the IPv4 address in a.b.c.d format. MTU Specifies the MTU for the inband management interface. The valid range is 1260 to 1500. This operand is optional. delete Deletes the specified IP Address for the inband management interface. IPv4_address Specifies the IP address to be deleted. disable Disables the inband management interface at the specified GbE Port. Brocade Fabric OS Command Reference 627 53-1004112-02