Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 766

portCfgTdz portCfgTdz Configures a port for Target Driven Zoning (TDZ). Synopsis portcfgtdz --enable [slot/]port_list portcfgtdz --disable [slot/]port_list portcfgtdz --show [slot/]port_list portcfgtdz --help Description Use this command to configure a port to support Target Driven Zoning. This command enables or disables the Target Driven Zoning configuration on the specified port and saves the configuration persistently. Target Driven Zoning can be configured on E_Ports, F_Ports, and L_Ports that are online or offline and it does not toggle the port to apply the configuration. After Target Driven Zoning is configured on the specified port, it allows the connected target device to configure Target Driven Peer Zones to be enabled and committed to the switch fabric. Notes The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric OS Commands" and "Command Availability" for details. When an FCS policy is enabled, this command can be issued only from the primary FCS switch. Operands This command has the following operands: slot For bladed systems only, specifies the slot number of the port on which the Target Driven Zoning configuration must be enabled or disabled, followed by a slash (/). port_list --enable Specifies one or more ports, relative to the slot on bladed systems. Use switchShow for a listing of valid ports. A port list should be enclosed in double quotation marks and can consist of the following: • A single port, for example, "8" or "5/8" on blades systems. • A port range where beginning and end port are separated by a dash, for example, "8-13" or "5/8-13" on blades systems. A port range cannot span multiple slots. • A set of ports separated by commas, for example "3,5,7,8" or "5/3,5,7,8" on bladed systems. • A wildcard * indicates all ports. The wildcard can be represented as '*' or "*". Enables the Target Driven Zoning configuration on the specified port. --disable Disables the Target Driven Zoning configuration on the specified port. --show Displays the current Target Driven Zoning configuration status (ON or OFF) for the specified port. --help Displays the command usage. 742 Brocade Fabric OS Command Reference 53-1004112-02