Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 851

portShow The behavior of this command is platform-specific. Some command options are not available on all platforms. Use the following section headings to navigate this page. • Display general port status information on all platforms • Display IP Interface configurations on the Brocade 7840, SX6, or FX8-24 platforms: - portshow ipif - Displays the local IP interfaces. - portshow arp - Displays the content of the address resolution protocol (ARP) table. - portshow iproute - Displays static routes on the IP interface. - portshow vlantag - Displays the IP interface VLAN configuration. Supported on the Brocade FX8-24 only. - portshow autoneg - Displays autonegotiation status. - portshow ipsec-policy - Displays the IPSEC Policy information. Supported on Brocade 7840 switch and the Brocade SX6 extension blade only. - portshow mgmtif - Displays the inband management interfaces. Supported on the Brocade FX8-24 only. - portshow mgmtroute - Displays the routes for the inband management interfaces. Supported on the Brocade FX8-24 only. - portshow lag - Displays the static link aggregation group (LAG) information. Supported on the Brocade 7840 switch and the Brocade SX6 extension blade only. - portshow tcl - Displays the Traffic Control List (TCL) information. Supported on the Brocade 7840 switch and the Brocade SX6 extension blade only. - portshow lan-stats - Displays the LAN statistics. Supported on the Brocade 7840 switch and the Brocade SX6 extension blade only. - portshow sla - Displays the Service Level Agreement (SLA) statistics. Supported on the Brocade 7840 switch and the Brocade SX6 extension blade only. • Display extension tunnels, circuits, management interfaces and FICON statistics on the Brocade 7840, SX6, or FX8-24 platforms: - portshow fciptunnel - Displays extension tunnels. - portshow fcipcircuit - Displays extension circuits. - portShow xtun - Displays FICON and FCP emulation statistics and current runtime conditions. To display the command usage on the switch, use portShow [action]. Notes The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric OS Commands" and "Command Availability" for details. Some of the features supported by this command may require a license. In an AD context, if one of the L_Ports or NPIV ports is a part of the current AD, the complete device information attached to the port is shown in the output. Function General port status display commands supported on all platforms Synopsis portshow [slot/][ge]port portshow -i [index1[-index2] [...]] [-f] portshow -x [hex1[-hex2] [...]] portshow -pid pid Brocade Fabric OS Command Reference 827 53-1004112-02