Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 928

portSwap portSwap Swaps two ports or removes swapping of ports. Synopsis portswap [slot1/]port1 [slot2/]port2 portswap --restore Description Use this command to swap the 24-bit port address (PID) for a pair of ports or to remove swapping of ports. When swapping both ports must be disabled prior to executing this command and the port-swapping feature must be enabled using portSwapEnable. The result of this operation is persistent across reboots and power cycles. Use portSwapShow to display the swapped ports along with their new port address Port swap information is kept in its own database; it cannot be manipulated by editing the configuration database displayed by configShow and configUpload. To undo a previous port swap, execute portSwap again on the same two ports. Notes The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric OS Commands" and "Command Availability" for details. TI zoning is not supported on E_Ports or F_Ports that are configured as part of a TI Zone with ports swapped. To work around this issue, reconfigure TI zoning rather than swapping the ports. This command is not allowed if one or both the ports are from a faulty blade. Operands This command has the following operands: slot1 For bladed systems only, specifies the slot number of the first port whose area number is to be swapped, followed by a slash (/). port1 Specifies the number of the first port whose address is to be swapped, relative to its slot for bladed systems. Use switchShow to display a listing of valid ports. slot2 For bladed systems only, specifies the slot number of the second port whose area number is to be swapped, followed by a slash (/). port2 Specifies the number of the second port whose port address is to be swapped, relative to its slot for bladed systems. --restore Removes swapping of all ports. 904 Brocade Fabric OS Command Reference 53-1004112-02