Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 753

portCfgShow Rate Limit Displays ON when ingress rate limit is set on the port or (..) or OFF when the ingress rate limiting feature is disabled. This value is set by the portCfgQos --setratelimit command. The default value is OFF. Credit Recovery Displays ON when Credit Recovery is enabled on the port. Displays (..) or OFF when the feature is disabled. This value is set by the portCfgCreditRecovery command. The credit recovery feature is enabled by default. Port Auto Disable Displays On when the Auto Disable feature is enabled on a port. Displays (..) or OFF when the feature is disabled. This feature causes ports to become disabled when they encounter an event that would cause them to reinitialize. This feature is enabled by the portCfgAutoDisable command. The feature is disabled by default. In the single port view, the configured trigger conditions are displayed when the feature is disabled. Refer to the example section for an illustration. F_Port Buffers Displays the number of configured F_Port buffers. Displays (..) or OFF if no buffers are configured. The buffer value is set by the portCfgfPortbuffers command. E_Port Credits Displays the number of configured E_Port credits. Displays (..) or OFF if no credits are configured. The credit value is set by the portCfgEportCredits command. CSCTL mode Displays ON if CSCTL mode is enabled on the port. Displays (..) or OFF if the feature is disabled. This parameter is set with the portCfgQos command. TDZ mode Displays ON when Target Driven Zoning (TDZ) is enabled on a port and the port is online or offline. Displays (..) or OFF when the configuration is disabled. TDZ is enabled by the portCfgTdz command; it is disabled by default. D_Port mode Displays ON when the port is configured as a D_Port; otherwise displays (..) or OFF. Refer to the portCfgDPort command for more information. This parameter is displayed only on on 16 Gbps-capable blades that support D_Port capability. D_Port over DWDM Displays ON when dwdm is enabled on that port using the portcfgdport command. This option is used to set if the link connecting two switches is a DWDM (Dense Wavelength Division Multiplexing) link. However, it can be set on normal links also. Fault Delay Displays the Fault delay value. Displays 0 if the value is R_A_TOV. This is the default. Displays 1 if the value is 1.2 seconds. This value is set by the portCfgFaultDelay command. valid for FC ports only. Compression Displays ON when compression is enabled on a port. Displays (..) or OFF when the configuration is disabled. Compression is enabled by the portCfgCompress command; it is disabled by default. Brocade Fabric OS Command Reference 729 53-1004112-02