Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 862

portShow 838 --link-local arp --link-local -lmac vlantag Perm Perm Net App autoneg ipsec-policy mgmtif mgmtroute lag --detail Displays the link-local interface routes. This operand is optional. Displays the address resolution protocol (ARP) and IPv6 neighbor discovery table. You can display the content of the ARP table, but you cannot modify its contents. Displays the neighbor discovery entries for the link-local addresses. This operand is optional. Displays the local MAC address. This operand is optional. Displays the VLAN Tagging configuration. For each entry, the output displays the IP interface address, the destination IP address, the VLAN ID, the L2 CoS priority, and a flag. This display includes tunnel- and IPIF-level configurations. The following flags indicate the type of configuration: Permanent entry. Permanent entries are configured at the IP interface level with the portCfg vlantag command. Network-wide permanent entry. The same as the permanent entry except that no destination address was defined (defaults to 0.0.0.0), so traffic to all destinations is tagged. Application layer VLAN configuration defined at the circuit level. Displays the auto-negotiation status. Displays IPSEC Policy information. Currently supported on Brocade 7840 switch only. Displays the inband management interfaces configured for a specified GbE Port or for all GbE Ports. For each GbE Port, the display includes the interface status (enabled or disabled), the interface IPv4 Address, the netmask, effective MTU, and annotated port flags. Displays the management routes configured for a specified GbE Port or for all GbE Ports. For each GbE Port, the display includes the destination IPv4 Address, the netmask, the gateway address, and annotated port flags. Displays the static LAG information. For each entry, the output displays the LAG name, state, port count, and member ports. Displays a full view configuration details for all LAGs. The output displays the operational state of LAG, port count, and the admin state, operational state, speed, and autonegotiation status for the port members. Brocade Fabric OS Command Reference 53-1004112-02