Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 620

pathInfo pathInfo Displays routing information and statistics along a path covering multiple switches. Synopsis pathinfo pathinfo -f FID dest_switch_domain [source_port] [dest_port] [-sid source_pid] [-did dest_pid] [-r] [-t] pathinfo dest_switch_domain [source_port] [dest_port] [-sid source_pid] [-did dest_pid] [-r] [-t] pathinfo --help Description Use this command to display routing information from a source port on the local switch to a destination port on another switch. The command output describes the exact data path between these ports, including all intermediate switches. When using pathInfo across fabrics connected through an FC Router, the command represents backbone information as a single hop. The command captures details about the FC Router to which ingress and egress EX_Ports are connected, but it hides the details about the path the frame traverses between the ingress EX_Ports to the egress EX_Ports in the backbone. To use pathInfo across remote fabrics, you must specify both the fabric ID (FID) and the domain ID of the remote switch. You cannot use the command to obtain source port information across remote FCR fabrics. When obtaining path info across remote fabrics, the destination switch must be identified by its Domain ID. Identifying the switch by name or WWN is not accepted. The command does not retry if there is a timeout or failure. It may fail if a switch along the path is busy or does not support this feature. If the advanced performance tuning (APT) policy in effect on the intermediate switches is not a port-based policy, subsequent data streams may not take the same path as displayed in the pathInfo output. Refer to aptPolicy for more information on advanced performance tuning policies. If you specify an inactive port or a path through a switch that does not have active routing tables to the destination, this command describes the path that would be taken if the ports were active. If you specify a destination port that is not active, this command uses the embedded port as the destination. The ingress and egress points above 256 are specified as port index. Use switchShow for a listing of valid port index numbers. To display the TI-enabled path across FCR, you must specify both source ID (SID) and destination ID (DID). The DID must be the proxy device ID and you can view the proxy device IDs using the nsAllShow command. In addition, pathInfo can provide statistics on every traversed interswitch link (ISL) that is part of the path. This feature is available only in the interactive command mode. The routing and statistics information are provided by every switch along the path, based on the current routing table information and statistics calculated continuously in real-time. Each switch represents one hop of the total path. 596 Brocade Fabric OS Command Reference 53-1004112-02